180
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
4.9.2 Symbology
Selection
4.9.3 Aztec Code
Aztec Code
Enable / Disable
Enables/disables the ability of the reader to decode Aztec Code labels.
Aztec Code
Length Control
This feature specifies either variable length decoding or fixed length decoding for this symbology.
Variable Length:
For variable length decoding, a minimum and maximum length may be set.
Fixed Length:
For fixed length decoding, two different lengths may be set.
Aztec Code Set Length 1
Specifies one of the barcode lengths for
Aztec Code Length Control on page 180
. Length 1 is the
minimum label length if in
Variable Length
Mode, or the first fixed length if in Fixed Length Mode.
Characters can be set from 0001 to 3,832 characters in increments of 0001 (pad with zeroes).
See
for detailed instructions on setting this feature.
Aztec Code = Disable
Aztec Code = Enable
DEFAULT
AZEN00(CR
CAZEN01(CR
Aztec Code Length Control = Variable Length
Aztec Code Length Control = Fixed Length
Select Aztec Code Length 1 Setting
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in
Appendix 18, Use the barcodes in this
appendix to enter numbers as you would
select digits/characters from a keypad.
rep-
resenting your desired character(s). End by
reading the ENTER/EXIT barcode again.
DEFAULT
AZLC00(CR
CAZLC01(CR
$CAZL1
