188
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Data Matrix Set Length 2
This feature specifies one of the barcode lengths for
Data Matrix Length Control on page 187
.
Length 2 is the maximum label length if in Variable Length Mode, or the second fixed length if in
Fixed Length Mode. Characters can be set from 0001 to 3,116 characters in increments of 0001
(pad with zeroes).
See
for detailed instructions on setting this feature.
Select Data Matrix Length 2 Setting
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in
Appendix 18, Use the barcodes in this
appendix to enter numbers as you would
select digits/characters from a keypad.
rep-
resenting your desired character(s). End by
reading the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
CANCEL
$CDML2
~
DEFAULT
Length 2 is 3,116 Characters
