202
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Micro QR Code Set Length 1
Specifies one of the barcode lengths for
Micro QR Code Length Control on page 201
. Length 1 is
the minimum label length if in
Variable Length
Mode, or the first fixed length if in Fixed Length
Mode. Characters can be set from 0001 to 0035 characters in increments of 0001 (pad with
zeroes).
See
for detailed instructions on setting this feature.
Select Micro QR Code Length 1 Setting
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in
Appendix 18, Use the barcodes in this
appendix to enter numbers as you would
select digits/characters from a keypad.
rep-
resenting your desired character(s). End by
reading the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
CANCEL
$CMQL1
~
DEFAULT
0001 = Length 1 is 1 Character
