243
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
5
References
5.5
Reading
Features
5.5.1 Scan Mode
This mode is associated with typical handheld reader operation. Selects the scan operating mode
for the reader. The following selections are valid for all models:
Trigger Single: When the trigger is pulled, reading is activated until one of the following occurs:
-
Reading Active Time on page 245
has elapsed
- a label has been read
- the trigger is released
Trigger Hold Multiple: When the trigger is pulled, reading starts and the product scans until the
trigger is released or
Reading Active Time on page 245
has elapsed. Reading a label does not
disable reading.
Double Read Timeout on page 70
prevents undesired multiple reads of the same
label while in this mode.
Trigger Pulse Multiple: When the trigger is pulled, continuous reading is activated until
has elapsed or the trigger has been released and pulled again.
prevents undesired multiple reads of the same label while in this mode.
Flashing: The reader flashes on and off regardless of the trigger status. Flash rate is controlled by
and
. When Flash is ON the imager
reads continuously; when Flash is OFF reading is deactivated.
Always On: No trigger pull is required to read a barcode. Reading is continually on. If the trigger is
pulled, the reader acts as if it is in Trigger Single Mode.
Double Read Timeout on page 70
pre-
vents undesired multiple reads of the same label while in this mode.
Stand Mode: No trigger pull is required to read a barcode. Reading is turned on automatically
when an item is placed in the reader’s field of view. If the trigger is pulled, the reader acts as if it in
single read mode.
Double Read Timeout on page 70
prevents undesired multiple reads while in
this mode.
