27
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
3
Setup
The link label is a Code 128 function 3 label with the following format:
<FN3 char>LnkB<12 character Bluetooth address>
4
Scan the link label you created in step 3.
Power Off
Shuts off power to the BT handheld until the next trigger pull. This function only applies to the BT
model.
3.5
Interface
Selection
Upon completing the physical connection between the reader and its host, proceed to
Table 1
starting on page 28
to select the interface type the reader is connected to (for example: RS-232,
USB, etc.). Scan the appropriate barcode in that section to configure your system’s correct inter-
face type.
3.5.1 Setting the
Interface
Scan the programming barcode from this section which selects the appropriate interface type
matching the system the reader will be connected to. Next, proceed to the corresponding section
in this manual (also listed in
Table: Available Interfaces on page 28
) to configure any desired set-
tings and features associated with that interface.
The Bluetooth address can be found under "Properties" within in the Blue-
tooth setup menu.
PowerOff
Unlike some programming features and options, interface selections require
that you scan only one programming barcode label. DO NOT scan an
ENTER/EXIT barcode prior to reading an interface selection barcode.
Some interfaces require the reader to start in the disabled state when pow-
ered up. If additional reader configuration is desired while in this state, pull
the trigger and hold it for five seconds. The reader will change to a state that
allows programming with barcodes.
