57
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
4.6.1 Global Prefix/
Suffix
This option sets up to 20 characters each from the set of ASCII characters or any hex value from
00 to FF. The characters may be added as a prefix (in a position before the barcode data, also
called a header) and/or as a suffix (in a position following the barcode data, also called a footer).
for more detailed instructions on setting this feature.
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE barcode above to place
the unit in Programming Mode, then the “Set Global Prefix” or “Set Global Suffix,” barcode fol-
lowed by the digits (in hex) from the Alphanumeric characters in
Appendix D, Use the barcodes in
this appendix to enter numbers as you would select digits/characters from a keypad.
your desired character(s). If less than the expected string of 20 characters are selected, scan the
ENTER/EXIT barcode to terminate the string. Exit programming mode by reading the ENTER/EXIT
barcode again.
Set Global Prefix
Set Global Suffix
Make a mistake? Scan the CANCEL barcode to
abort and not save the entry string. You can
then start again at the beginning.
CANCEL
$CLFPR
$CLFSU
~
DEFAULT
No Global Prefix
Global Suffix = 0x0D (CR)
