80
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Stand Illumination Control
Controls the illumination status while the reading mode is stand mode and the reader is attempt-
ing to detect objects.
Flash On Time
This feature specifies the ON time for the indicator LED while in Flash Mode. The selectable range
is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments. See
in
“References” for detailed information on setting this feature.
Stand Illumination Control = OFF
Stand Illumination Control = ON
Stand Illumination Control = Dim
Select Flash ON Time Setting
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in
Appendix 18, Use the barcodes in this
appendix to enter numbers as you would
select digits/characters from a keypad.
rep-
resenting your desired character(s). End by
reading the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
CANCEL
DEFAULT
CSMIL00(CR)
CSMIL01(CR)
CSMIL02(CR)
$CSNFN
~
DEFAULT
10 = Flash is ON for 1 Second
