121
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Code 128 Set Length 1
Specifies one of the barcode lengths for
Code 128 Length Control on page 120
. Length 1 is the
minimum label length if in
For variable length decoding, a minimum and maxi-
mum length may be set. on page 231
Mode, or the first fixed length if in
length decoding, two different lengths may be set. on page 231
Mode. Length includes the bar-
code’s data characters only. The length can be set from 1 to 80 characters.
Table Code 128 Length 1 Setting Examples
provides some examples for setting Length 1. See
for detailed instructions on setting this feature.
Code 128 Length
1 Setting
Examples
STEP
ACTION
EXAMPLES
1
Desired Setting
01 Character
07 Characters
15 Characters
80 Characters
2
Scan ENTER/EXIT PROGRAMMING MODE
3
Scan SELECT CODE 128 LENGTH 1 SETTING
4
‘0’ and ‘1’
‘0’ and ‘7’
‘1’ and ‘5’
‘8’ AND ‘0’
5
Scan ENTER/EXIT PROGRAMMING MODE
Select Code 128 Set Length 1 Setting
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You can
then start again at the beginning.
CANCEL
$CC8L1
~
DEFAULT
01 = Length 1 is 1 Character
