135
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Standard 2 of 5 Set Length 1
This feature specifies one of the barcode lengths for
Standard 2 of 5 Length Control on page 134
.
Length 1 is the minimum label length if in
For variable length decoding, a mini-
mum and maximum length may be set. on page 134
Mode, or the first fixed length if in
For fixed length decoding, two different lengths may be set. on page 111
includes the barcode’s check and data characters. The length can be set from 1 to 50 charac-
ters.
Table Standard 2 of 5 Length 1 Setting Examples
provides some examples for setting Length 1.
if you want detailed instructions on setting this feature.
Standard 2 of 5
Length 1 Setting
Examples
STEP
ACTION
EXAMPLES
1
Desired Setting
01 Character
07 Characters
15 Characters
50 Characters
2
Scan ENTER/EXIT PROGRAMMING MODE
3
Scan SELECT STANDARD 2 OF 5 LENGTH 1 SETTING
4
‘0’ and ‘1’
‘0’ and ‘7’
‘1’ and ‘5’
‘5’ AND ‘0’
5
Scan ENTER/EXIT PROGRAMMING MODE
Select Standard 2 of 5 Length 1 Setting
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You can
then start again at the beginning.
CANCEL
$CS2L1
~
DEFAULT
08 = Length 1 is 8 Characters
