136
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Standard 2 of 5
Set Length 2
This feature specifies one of the barcode lengths for
Standard 2 of 5 Length Control on page 134
Length 2 is the maximum label length if in
For variable length decoding, a mini-
mum and maximum length may be set. on page 134
Mode, or the second fixed length if in
For fixed length decoding, two different lengths may be set. on page 111
Mode. Length
includes the barcode’s check and data characters.
The length can be set from 1 to 50 characters. A setting of 0 specifies to ignore this length (only
one fixed length).
Table Standard 2 of 5 Length 2 Setting Examples
provides examples for setting Length 2. See
for detailed instructions on setting this feature.
Standard 2 of 5
Length 2 Setting
Examples
STEP
ACTION
EXAMPLES
1
Desired Setting
(pad with
leading zeroes)
00 (Ignore
This Length)
07 Characters
15 Characters
50 Characters
2
Scan ENTER/EXIT PROGRAMMING MODE
3
Scan SELECT STANDARD 2 OF 5 LENGTH 2 SETTING
4
Scan Two
Characters
From
‘0’ and ‘0’
‘0’ and ‘7’
‘1’ and ‘5’
‘5’ AND ‘0’
5
Scan ENTER/EXIT PROGRAMMING MODE
Select Standard 2 of 5 Length 2 Setting
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You can
then start again at the beginning.
CANCEL
$CS2L2
~
DEFAULT
50 = Length 2 is 50 Characters
