153
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Code 11 Set Length 1
This feature specifies one of the barcode lengths for
Code 11 Length Control on page 152
.
Length 1 is the minimum label length if in
For variable length decoding, a mini-
mum and maximum length may be set. on page 231
Mode, or the first fixed length if in
For fixed length decoding, two different lengths may be set. on page 231
includes the barcode’s check and data characters. The length can be set from 2 to 50 charac-
ters.
Table Code 11 Length 1 Setting Examples
provides some examples for setting Length 1. See
for detailed instructions on setting this feature.
Code 11 Length
1 Setting
Examples
STEP
ACTION
EXAMPLES
1
Desired Setting
(pad with
leading zeroes)
02 Characters
07 Characters
15 Characters
50 Characters
2
Scan ENTER/EXIT PROGRAMMING MODE
3
Scan SELECT CODE 11 LENGTH 1 SETTING
4
Scan Two
Characters
From
‘0’ and ‘2’
‘0’ and ‘7’
‘1’ and ‘5’
‘5’ AND ‘0’
5
Scan ENTER/EXIT PROGRAMMING MODE
Select Code 11 Set Length 1 Setting
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You can
then start again at the beginning.
CANCEL
$CC1L1
~
DEFAULT
04 = Length 1 is 4 Characters
