167
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Code 93 Set Length 2
This feature specifies one of the barcode lengths for
Code 93 Length Control on page 165
.
Length 2 is the maximum label length if in
For variable length decoding, a mini-
mum and maximum length may be set. on page 231
Mode, or the second fixed length if in
For fixed length decoding, two different lengths may be set. on page 231
includes the barcode’s check, data, and full-ASCII shift characters. The length does not include
start/stop characters. The length can be set from 1 to 50 characters. A setting of 0 specifies to
ignore this length (only one fixed length).
Table CODE 93 Length 2 Setting Examples
provides examples for setting Length 2. See
for detailed instructions on setting this feature.
CODE 93 Length
2 Setting
Examples
STEP
ACTION
EXAMPLES
1
Desired Setting
00 (Ignore
This Length)
07
Characters
15
Characters
50 Characters
2
Scan ENTER/EXIT PROGRAMMING MODE
3
Scan SELECT CODE 93 LENGTH 2 SETTING
4
Scan Two
Characters From
‘0’ and ‘0’
‘0’ and ‘7’
‘1’ and ‘5’
‘5’ AND ‘0’
5
Scan ENTER/EXIT PROGRAMMING MODE
Select Code 93 Length 2 Setting
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You can
then start again at the beginning.
CANCEL
$CC9L2
~
DEFAULT
50 = Length 2 is 50 Characters
