217
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Direct Radio
Autolink
This feature enables/disables the ability to link a wireless handheld to a base station without read-
ing the Unlink label first.
4.10.1Bluetooth-Only
Features
The features following in this section are valid only for QuickScan Bluetooth models. Also refer-
ence the Setup section for instructions on
Linking a BT Reader to a PC, starting on page 26
.
RF Address
Stamping
These features allow configuration of source radio data inclusion.
Source Radio Address Transmission
Enables/disables the ability of source radio address information to be transmitted to the host and,
if so, at what position with respect to the label data. See
in “References” for detailed
information and examples for setting this feature.
Direct Radio Link = Unlink Label Required
Direct Radio Link = Automatic Unlinking
DEFAULT
$CBT-
$CBT-
When included as a prefix, the source-radio ID is displayed after all label for-
matting has been applied. The 6 byte hex address is sent as 12 ascii char-
acters, i.e., an address of 00 06 66 00 1A ED will be sent as (shown in hex):
30 30 30 36 36 36 30 30 31 41 45 44
Source Radio Address Transmission = Do
Not Include
Source Radio Address Transmission = Prefix
DEFAULT
$CBTAS00(CR
$CBTAS01(CR
