220
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Select PIN Code Length
Set PIN Code
Determine the desired characters for the PIN code, then convert to hexadecimal using the
on the inside back cover of this manual. See
for detailed information and
examples for setting this feature.
Select 4-character BT PIN Code
Select 16-character BT PIN Code
Set 4-character BT PIN Code
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in
Appendix 18, Use the barcodes in this
appendix to enter numbers as you would
select digits/characters from a keypad.
rep-
resenting your desired character(s). End by
reading the ENTER/EXIT barcode again.
Set 16-character BT PIN Code
CANCEL
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
CBTPS00\r
DEFAULT
$CBTPS01\r
$CBTPC
$CBTP6
~
DEFAULT
31323334 = Default PIN Code is 1234
