229
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
5
References
ACK NAK Retry
Count
This feature specifies the number of times the reader retries a label transmission due to a retry
condition. The selectable range is from 1 to 254 retries. A selection of 0 disables the count, and a
selection of 255 specifies unlimited retries.
To set this feature:
1
Determine the desired setting.
2
Pad the number with leading zeroes to yield three digits. For example: 0 = 000, 5 = 005, 20 =
020, etc.
3
Go to
and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Pro-
gramming Mode.
4
Scan the barcode: SELECT ACK NAK RETRY COUNT SETTING.
5
Scan the appropriate three digits from the keypad in
Appendix 18, Use the barcodes in this
appendix to enter numbers as you would select digits/characters from a keypad.
, that repre-
sent the number which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
6
Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure. See
Table ACK NAK Retry Count Setting Examples
examples of how to set this feature.
ACK NAK Retry
Count Setting
Examples
If you make a mistake before the last character, scan the CANCEL barcode
to abort and not save the entry string. You can then start again at the begin-
ning.
STEP ACTION
EXAMPLES
1
Desired Setting
Disable Retry
Count
3 Retries
54 Retries
Unlimited Retries
2
Pad with leading
zero(es)
000
003
054
255
3
Scan ENTER/EXIT PROGRAMMING MODE
4
Scan SELECT ACK NAK RETRY COUNT SETTING
5
Scan Three
Characters From
‘0’, ‘0’ and
‘0’
‘0’, ‘0’ and
‘3’
‘0’, ‘5’ and
‘4’
‘2’, ‘5’ and ‘5’
6
Scan ENTER/EXIT PROGRAMMING MODE
