248
BVS HS-Q Series
Standard Hand Held Barcode Reader
5
References
5.5.6 Flash Off Time
This feature specifies the OFF time for the indicator LED while in Flash Mode. The selectable
range is 100 to 9,900 milliseconds (0.1 to 9.9 seconds), in 100 millisecond increments.
Follow these instructions to set this feature.
1
Determine the desired setting in milliseconds.
2
Divide the desired setting by 100 (setting is in 100ms increments). Pad the result with leading
zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
3
and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Pro-
gramming Mode.
4
Scan the barcode: SELECT FLASH OFF TIME SETTING.
5
Scan the appropriate two digits from the keypad in
Appendix 18, Use the barcodes in this
appendix to enter numbers as you would select digits/characters from a keypad.
, that repre-
sent the duration which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
6
Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
This completes the procedure. See
Table Flash Off Time Setting Examples
for some examples of
how to set this feature.
Flash Off Time
Setting
Examples
If you make a mistake before the last character, scan the CANCEL barcode
to abort and not save the entry string. You can then start again at the begin-
ning.
STEP ACTION
EXAMPLES
1
Desired Setting
500ms
1,000ms
(1 sec.)
5200ms
(5.2 sec.)
9,900ms
(9.9 sec.)
2
Divide by 100 (and pad
with leading zeroes to
yield two digits)
05
10
52
99
3
Scan ENTER/EXIT PROGRAMMING MODE
4
Scan SELECT FLASH OFF TIME SETTING
5
Scan Two Characters
From
the barcodes in this
appendix to enter
numbers as you would
select digits/characters
from a keypad.
‘0’ and ‘5’
‘1’ and ‘0’
‘5’ and ‘2’
‘9’ and ‘9’
6
Scan ENTER/EXIT PROGRAMMING MODE
