253
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
5
References
5.6.3 BT Features
BT Pin Code
This option specifies the 4-character or 16-character pin code to be used for authentication of the
BT link. To set the pin code:
1
Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming Mode, then
enable
2
Specify the desired pin code length (4 or 16) by reading the appropriate barcode in
3
Determine the desired characters. For example, D254 or STOR12345678135M
4
Convert the characters to hexadecimal using the
on the inside back cover of
this manual.
5
Go to
and Scan the barcode: SET 4 CHAR PIN CODE or SET 16-CHAR PIN CODE.
6
Scan the appropriate alphanumeric characters from the keypad in
codes in this appendix to enter numbers as you would select digits/characters from a key-
pad.
, representing the hexadecimal entries determined in the steps above. You will hear a
two-beep indication after the last character.
7
Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming Mode.
Figure 5:
BT Pin Code Setting Examples
If you make a mistake before the last character, scan the CANCEL barcode to
abort and not save the entry string. You can then start again at the beginning.
Changing the pin code setting will unlink the devices. If the Automatic Configura-
tion Update is set to the default enabled setting, the devices must only be
relinked.
Do not use this setting if AUTOMATIC CONFIGURATION UPDATE is set to
"Disabled"! Please check this setting first before going on.
STEP ACTION
EXAMPLES
1
Desired Setting
D254
STOR12345678135M
2
Convert the
characters to
hexadecimal
44 32 35 34
53 54 4F 52 31 32 33 34 35 36
37 38 31 33 35 4D
3
Scan ENTER/EXIT PROGRAMMING MODE
4
Scan SET BT PIN CODE
5
Scan 8 or 32
Alphanumeric
Characters From
44323534
53544F5231323334353637383133354D
6
Scan ENTER/EXIT PROGRAMMING MODE