29
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
3
Setup
3.6.2 Global Interface
Features
"Global Interface Features" on page 32
for settings configurable by all interface types.
3.6.3 Configuring
Other Features
If your installation requires different programming than the standard factory default settings, the
following sections of this manual allow configuration of non-interface-specific settings you might
require:
Data Format
Data Format offers options to control the messages sent to the Host system.
Reading Parameters
Reading Parameters include programming for reading, beeper and LED indicators and other uni-
versal settings.
Symbology-Specific Parameters
1D Symbologies
Includes options concerning the barcode label types (symbologies). These settings allow you to
enable/disable symbologies, set label lengths, require check digit, etc.
2D Symbologies
Includes options concerning the barcode label types (symbologies). These settings allow you to
enable/disable symbologies, set label lengths, require check digit, etc.
3.6.4 Software Version
Transmission
The software version of the device can be transmitted over the RS-232 and Keyboard interfaces
by reading the following label.
3.6.5 Resetting the
Product
Configuration to
Defaults
Restore Custom Defaults
If you aren’t sure what programming options are in your imager, or you’ve changed some options
and want to restore the Custom Default Configuration that may have been saved in the reader,
scan the Restore Custom Default Configuration barcode below. This will restore the custom con-
figuration for the currently active interface.
Restore Factory Configuration
If you want to restore the Factory Configuration for your imager, scan either the Restore USA Fac-
tory Configuration barcode or the Restore EU Factory Configuration barcode below. Both labels
restore the reader configuration to the factory settings, including the interface type.
Transmit Software Version
Custom defaults are based on the interface type. Configure the imager for
the correct interface before reading this label.
Restore Custom Default Configuration
