32
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
4
Complete the programming sequence by reading the ENTER/EXIT PROGRAMMING barcode
to exit Programming Mode.
For more detailed descriptions, programming information and examples for setting selected con-
figuration items, see
.
Global Interface
Features
The following interface features are configurable by all interface types.
Host Commands — Obey/Ignore
This option specifies whether the reader will obey or ignore host commands. When set to ignore,
the reader will ignore all host commands except for those necessary for:
- service mode
- flash programming mode
- keeping the interface active
- transmission of labels.
USB Suspend
Mode
This setting enables/disables the ability of USB interfaces to enter suspend mode.
By default, the handheld will decode barcode labels only when they are
close to the center of the aiming pattern. This allows the handheld to accu-
rately target labels when they are placed close together, such as on a pick
sheet. See
Host Commands = Obey
(Do Not Ignore Host Commands)
Host Commands = Ignore
DEFAULT
$CIFIH00(CR)
$CIFIH01(CR)
USB Suspend Mode = Disable
USB Suspend Mode = Enable
DEFAULT
CUSSE00(C
$CUSSE01(C
