42
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
ACK NAK Retry
Count
This feature specifies the number of times the reader retries a label transmission due to a retry
condition. The selectable range is from 1 to 254 retries. A selection of 0 disables the count, and a
selection of 255 specifies unlimited retries.
See page 229
for more information.
ACK NAK Error
Handling
This feature specifies the method the reader uses to handle receive errors detected while waiting
for an ACK character from the host.
Select ACK NAK Retry Count Setting
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in
Appendix D
appendix to enter numbers as you would
select digits/characters from a keypad.
senting your desired character(s). End by
reading the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
CANCEL
$CR2AR
~
DEFAULT
003 = 3 Retries
ACK NAK Error Handling =
Ignore Errors Detected
ACK NAK Error Handling =
Process Error as Valid ACK Character
ACK NAK Error Handling =
Process Error as Valid NAK Character
DEFAULT
EH00(CR
2EH01(CR
EH02(CR
