43
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Indicate
Transmission
Failure
This option enables/disables the reader’s ability to sound an error beep to indicate a transmission
failure while in ACK/NAK mode
.
Disable
Character
Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
for more information on setting this feature.
Indicate Transmission Failure =
Disable Indication
Indicate Transmission Failure =
Enable Indication
$CR2TF00(CR)
$CR2TF01(CR)
DEFAULT
Setting to previously defined characters such as XON, XOFF, or host com-
mands conflicts with normal operation of these characters. 8-bit data is not
recognized when the option
has been set as 7 Data Bits.
Select Disable Character Setting
$CR2DC
DEFAULT
0x44 = Disable Character is ‘D’