49
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Send Control
Characters
This feature specifies how the reader transmits ASCII control characters to the host. Reference
Appendix E, Appendix E: Scancode Tables
for more information about control characters.
Options are as follows:
Control Character 00
Characters from 00 to 0x1F are sent as control character Ctrl+Keys, special keys are located
from 0x80 to 0xA1.
Control Character 01
Characters from 00 to 0x1F are sent as control character Ctrl+Shift, special keys are located from
0x80 to 0xA1.
Control Character 02
Special keys are located from 00 to 0x1F and characters from 0x80 to 0xFE are intended as an
extended ASCII table (see
"Microsoft Windows Codepage 1252" on page 293
).
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface. The selectable range
for this feature is from 0 to 99 seconds.
in “References” for detailed information and examples for setting this feature.
Wedge Send Control Characters = 00
Wedge Send Control Characters = 01
Wedge Send Control Characters = 02
DEFAULT
$CKB-
$CKB-
$CKB-
Set Intercode Delay
To configure this feature, scan the ENTER/
EXIT PROGRAMMING MODE barcode
above, then the barcode at left followed by
the digits from the Alphanumeric characters
in
Appendix D, Use the barcodes in this
appendix to enter numbers as you would
select digits/characters from a keypad.
rep-
resenting your desired character(s). End by
reading the ENTER/EXIT barcode again.
$CKBID