77
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Stand Mode Indication
This operation is useful for indicating when the reader is in Stand Mode. If enabled, the blue indi-
cator will blink when Stand Mode reading is active. If the reader is removed from its Stand support
or from the Base Station (cordless models) and switches out of Stand Mode into Triggered Mode,
blinking will stop until Stand Mode is active again.
Stand Operation
Specifies the behavior of the reader when stationary in a stand. There are two conditions which
cause the reader to switch to Stand Mode:
1
The reader is manually configured to switch to Stand Mode or when inserted into the special
Stand support which automatically enables the Stand Mode.
2
The reader is placed into the cradle of the base station (cordless models only).
Below are further options concerning Stand Operation.
Ignore Autorecognition:
Disables mode switching when the reader is placed in a stand.
Change to Stand Mode:
Automatically switches the reader to Stand Mode when the reader is
placed in the stand.
Change to Flashing:
Automatically switches the reader to Flash Mode when the reader is
placed in the stand.
Change to Always On:
Automatically switches the reader to Always On mode when the reader
is placed in the stand.
Stand Mode Indication = Disable
Stand Mode Indication = Enable
Do Not Change Mode
Change to Stand Mode
Change to Always On
Change to Flashing
DEFAULT
$CSM-
FL00(CR)
$CSM-
FL01(CR)
$CSMSD00(C
R)
$CSMSD01(CR)
DEFAULT
$CSMSD02(C
$CSMSD03(C