82
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Aiming Duration Timer
Specifies the frame of time the aiming pointer remains on after decoding a label, when in trigger
single mode.The range for this setting is from 1 to 255 seconds in 1-second increments. See
in “References” for a description of this feature.
Aiming Off After Decoding
Set Aiming Duration Timer
To configure, scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in
representing your
desired character(s). End by reading the
ENTER/EXIT barcode.
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You
can then start again at the beginning.
CANCEL
DEFAULT
LSTM00
LSTM
~