85
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Multiple Label
Reading
In standard (default) mode, when the reader’s aiming system is activated (by a trigger pull, motion
or other method depending on the mode), it then acquires and processes each image in the area
in front of it (the Volume). In this case, the reader stops processing the image once it decodes a
label. If several labels are present in the volume, only the first label encountered is decoded and
sent.
When Multiple Reading Mode is enabled, the reader keeps on processing the image until all the
labels present are decoded. The reader then sorts the data from all the barcodes (if configured to
do so) before transmitting it.
Multiple Labels per Frame
Specifies the ability of the reader to decode and transmit a set of code labels in a specific volume
and in a single frame of time. When in Multiple Labels per Frame the reader beeps and turns on
the good read LED indication for each code read in a frame.
When Multiple Labels Mode is enabled, ISBT pairing, ABC Codabar pairing, and composites are
not allowed.
Multiple Labels per Frame = Disable
Multiple Labels per Frame = Enable
DEFAULT
$CSN-
$CSN-