262
BVS HS-Q Series
Standard Hand Held Barcode Reader
6
Appendix A: Technical Specifications
Programming
Programming Mode
- The following indications ONLY occur when the reader is in Program-
ming Mode.
Label Pro-
gramming
Mode Entry
A valid programming label
has been readed.
LED blinks continu-
ously
Reader sounds four low
frequency beeps.
Label Pro-
gramming
Mode Rejec-
tion of Label
A label has been rejected.
N/A
Reader sounds three
times at lowest frequency
& current volume.
Label Pro-
gramming
Mode Accep-
tance of Par-
tial Label
In cases where multiple
labels must be readed to
program one feature, this
indication acknowledges
each portion as it is suc-
cessfully readed.
N/A
Reader sounds one short
beep at highest frequency
& current volume.
Label Pro-
gramming
Mode Accep-
tance of Pro-
gramming
Configuration option(s)
have been successfully
programmed via labels
and the reader has exited
Programming Mode.
N/A
Reader sounds one high
frequency beep and 4 low
frequency beeps followed
by reset beeps.
Label Pro-
gramming
Mode Cancel
Item Entry
Cancel label has been
readed.
N/A
Reader sounds two times
at low frequency and cur-
rent volume.
Mode Indications
6.4
Error Codes
Upon startup, if the reader sounds a long tone, this means the reader has not passed its auto-
matic Selftest and has entered FRU (Field Replaceable Unit) isolation mode. If the reader is reset,
the sequence will be repeated. The following table describes the LED flashes/beep codes associ-
ated with an error found.
NUMBER OF
LED FLASHES/
BEEPS
ERROR:
All Models:
CORRECTIVE ACTION
1
Configuration
Contact Helpdesk for assis-
tance
2
Interface PCB
6
Digital PCB
12
Imager
