136
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Standard 2 of 5
Set Length 2
This feature specifies one of the barcode lengths for
Standard 2 of 5 Length Control on page 134
Length 2 is the maximum label length if in
Variable Length: For variable length decoding, a mini-
mum and maximum length may be set. on page 134
Mode, or the second fixed length if in
Length: For fixed length decoding, two different lengths may be set. on page 111
Mode. Length
includes the barcode’s check and data characters.
The length can be set from 1 to 50 characters. A setting of 0 specifies to ignore this length (only
one fixed length).
Table Standard 2 of 5 Length 2 Setting Examples
provides examples for setting Length 2. See
for detailed instructions on setting this feature.
Standard 2 of 5
Length 2 Setting
Examples
STEP
ACTION
EXAMPLES
1
Desired Setting
(pad with
leading zeroes)
00 (Ignore
This Length)
07 Characters
15 Characters
50 Characters
2
Scan ENTER/EXIT PROGRAMMING MODE
3
Scan SELECT STANDARD 2 OF 5 LENGTH 2 SETTING
4
Scan Two
Characters
From
‘0’ and ‘0’
‘0’ and ‘7’
‘1’ and ‘5’
‘5’ AND ‘0’
5
Scan ENTER/EXIT PROGRAMMING MODE
$CS2L2
Select Standard 2 of 5 Length 2 Setting
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You can
then start again at the beginning.
~
CANCEL
DEFAULT
50 = Length 2 is 50 Characters