240
BVS HS-Q Series
Standard Hand Held Barcode Reader
5
References
Label ID
Examples
STEP ACTION
EXAMPLES
1.
Scan the ENTER/EXIT
barcode
(Reader enters Programming Mode)
2.
Determine placement
of the Label ID
characters BEFORE or
AFTER with regard to
readed data using
Label ID
Control, starting on
page 61
Enable as
Prefix
Enable as
Suffix
Enable as
Prefix
Enable as Suffix
3.
Scan the barcode
selecting the
symbology type you
wish to designate
label ID characters for
using
Symbology Selection −
1D Symbologies, starti
ng on page 62
DataBar
Omnidirec-
tional
Code 39
Interleaved 2
of 5
Code 32
4.
Custom Label ID
example (desired
characters):
D B *
= C 3
+
P H
5.
Find hex equivalents
from the (inside back
cover), then scan in
these digits/
characters using the
barcodes in the
section:
. If you make
a mistake before the
last character, scan
the CANCEL barcode
to abort and not save
the entry string. You
can then start again at
the beginning.
44 42 2A
3D 43 33
2B
50 48
6.
Scan the ENTER/EXIT
barcode
(Reader exits Label ID entry)
7.
Scan the ENTER/EXIT
barcode once again
(Reader exits Programming Mode)
Result:
DB*[bar
code data]
[bar code
data]=C3
+[bar code
data]
[bar code
data]PH
