12
english
7
Operating mode (continued)
7.3
Teaching in switchpoints
t S
The output functions SP1 and SP2 are dependent
on the selected switching mode
Mod
and the
selected output configuration
out
(see
SP 1
►
Teach in switchpoint 1 and store as SP1.
SP2
►
Teach in switchpoint 2 and store as SP2.
7.4
Manually adjusting switchpoint 1
SP 1
►
Adjust the value (0…4095) using the
or
buttons.
⇒
The adjustment is effective immediately.
7.5
Manually adjusting switchpoint 2
SP2
►
Adjust the value (0…4095) using then
or
buttons.
⇒
The adjustment is effective immediately.
7.6
Configuration
[ ]conf
The configured settings are effective immediately.
The high teach value is assigned to SP1:
– higher dampening
– smaller object distance
The low teach value is assigned to SP2:
– smaller dampening
– larger object distance
7.6.1 Adjusting the switching power amplifier type
out
Display Configuration
P no
PNP N.O.
n no
NPN N.O.
PP no
Push-pull, actuated = high side
P nc
PNP N.C.
n nc
NPN N.C.
PP nc
Push-pull, actuated = low side
Tab. 7-3: Adjusting the switching power amplifier type
Adjusting the switching mode
Mod
After the switching mode is selected, the selection
for adjusting the switchpoints returns to the main
menu
t S
.
For examples of typical teach-in processes, see the figures
Standard switching mode
St d
The system generally works with only one defined switch-
point: object or fill level (half of active surface covered with
medium) reliably detected. If the measurement falls below
the switchpoint by a small amount, the output switches to
off
.
Fig. 7-1:
Sensor value
SP1
tS: SP1
tS: SP2
Output
On
Off
Standard switching mode
2-point switching
2Pt
Separate teach-in of switch-on point (menu 2 SP1) and
switch-off point (menu 2 SP2). The switchpoints can be set
very wide apart, e.g. to control a min. and max. (fill level).
Fig. 7-2:
Sensor value
SP1
SP2
tS: SP2
tS: SP1
Output
On
Off
2-point switching
BAE SA-CS-027-YI-BP00,3 GS04
IO-Link Sensor Amplifier
Summary of Contents for IO-Link BAE SA-CS-027-YI-BP00,3 GS04
