5
Bally Northwind Tool List
Two people are required to assemble a Bally Northwind. The following list will assist you on the tools
necessary in the assembly process.
1.
Caulk Gun (tube type)
2.
Utility Knife (for foam insulation)
3.
Foaming Kit (in the general miscellaneous box*)
4.
Speed Lock Wrench (in general miscellaneous box*)
5.
Tape Measure
6.
Level (at least 4 ft.)
7.
5/16 Nut Driver
8.
Straight Edge (i.e., carpenters square)
*You will find two Miscellaneous Parts Boxes: the General Box, with parts for the normal walk-in portion of the
job, and the Blast Chiller Miscellaneous Box, with dedicated parts of the Blast Chiller.
Bally Northwind 500 Parts List
1.
23” Panels [3]
2.
34 ½” Panel [1]
3.
Corners [4]
4.
Ceiling Panels [2]
5.
36” x 78”Door (
with electrical junction box, complete with twist-lock plug wiring).
[1]
6.
Control Panel
(with complete twist-lock plug wiring and buzzer with alarm switches)
[1]
7.
Fan rack (pre-assembled) with twist-lock plug wiring [1]
8.
Evaporator Coil (pre-assembled) with twist-lock plug wiring [1]
9.
Probes, thermocouple type K [3]
10.
Ceiling Plenum with light and twist-lock plug wiring [1]
11.
Top Coil Trim with J-box for Thermocouples[1]
12.
Top Fan Trim Piece [1] (Angled piece, approx. 4 x 36”)
13.
Coil and Fan Trim Pieces[2 each]
14.
Top Diagonal Air Deflectors
(for above Coil and Fan assembly)
[2].
15.
Universal food rack with tray supports [1]
16.
Door Anchor [2] (UNLESS there is a floor)
17.
¾” Stainless steel plug buttons, type 304 (48)
18.
Grey panel gasket for repair of damaged gaskets
