Bally Refrigerators/Freezers/Warmers, Installating And Operation Manual

- 9 - 

START-UP PROCEDURE 
ELECTRICAL CONNECTIONS 

To insure proper operation, your new model must be connected to an individual 
circuit that can supply the full voltage as stated on the cabinet serial data plate. For 
correct voltage, power draw, and wire accommodations, check the data on the 
serial data plate located on the inner right wall of your new model. Verify that this 
information exactly matches the electrical characteristics at the installation location. 
An electrical wiring diagram, located on the upper cabinet end panel next to the 
electrical console box, should also be consulted during connection. 
 

Important Note:

 T

he condensing unit supplied with all self-contained models is 

designed to operate with a voltage fluctuation of + 10 % of the voltage indicated on 
the cabinet serial data plate. Full voltage of the correct service, on an individual line 
not affected by the operation of other electrical appliances, must be available to the 
condensing unit at all times.

 Burnout of the compressor due to exceeding the 

high or low voltage limits is easily detected and will automatically void the 
factory warranty.

115 VOLT, 60 HZ, 1 PHASE CONNECTION 

All 115 volt models are provided with a U.L. approved power cord and polarized 
plug which is factory installed. 

Warning:

 Any alterations to this cord and plug could cause an electrical 

hazard and will void the factory warranty. 

To insure proper operation, this equipment must be plugged into a NEMA 5-15R 
compatible, grounded receptacle that can supply the full voltage as stated on the 
serial data plate. 
 
 

208-230 VOLT, 60 HZ, 1 PHASE CONNECTION 

All 208-230 volt models are to be permanently connected and are provided with 
four (4) field wiring leads which exit the electrical console box located in the 
machine compartment behind the front grill. The cabinet circuitry is 115 volts and 
the condensing unit is 208-230 volts in which the wiring includes a neutral and a 
mechanical ground. This wiring should be connected to the appropriate power 
source by a qualified electrician and must conform to all local electrical codes. 

SPECIAL VOLTAGE CONNECTIONS 

When models are ordered from the factory with special, optional voltages, 
connections should be made as required on the electrical wiring diagram provided 
on the upper cabinet end panel next to the electrical console box.