Bally Refrigerators/Freezers/Warmers, Installating And Operation Manual

- 4 - 

INSTALLING LEGS AND LEVELING REACH-IN MODELS 

Your new reach-in model is supplied with adjustable type legs for leveling 
purposes. Each single and two section model has four leg mounting holes on its 
case bottom, and three section models have six leg mounting holes. Legs are 
packed in the accessory carton from which they must be removed and installed on 
the cabinet case bottom (see figure 2). In order to install the legs, carefully tip the 
cabinet rearward adding four (4) 2" wood blocks underneath and simply screw the 
threaded leg studs into the case bottom front leg holes. Repeat this procedure by 
tilting the cabinet in the opposite direction and install the remaining legs. Make sure 
the legs are tightened extremely well or the entire model will sway or rock with each 
opening or closing of the doors, possibly causing damage to the case bottom. This 
procedure should be performed close to the final installation site and allow access 
to the rear of the cabinet for condensate evaporator installation (see "condensate 
evaporator installation" under installation and location section). 
 
To assure your cabinet is level, all legs are equipped with bullet-type leveling bolts. 
These bolts can be turned by hand or by wrench, clockwise or counterclockwise to 
level the cabinet. 
 

FIGURE 2 

LEG INSTALLATION 

MOUNTING ROLL-IN MODELS IN PLACE AND LEVELING 

Your new roll-in model is designed and constructed to be mounted directly on the 
floor without legs or casters. The floor 

must

 be level and the base of the cabinet 

should be sealed to the floor around its entire perimeter. If the floor is not level, it 
must be made level prior to mounting your roll-in model.  
 
Your roll-in model comes with one cart ramp per door opening. To install the 
ramp(s), simply open the cabinet door and position the ramp slots onto the screws 
located along the cabinet bottom front. If the door wiper rubs along the ramp to the 
extreme where the door will not self-close, you will need to adjust the door (see 
"door adjustment" section) or level the cabinet as explained above.