OPERATOR
’S MANUAL
with Maintenance Information
Operating Instructions
33
Battery and Charger
Instructions
Observe and Obey:
√
Do not use an external charger or booster
battery.
√
Charge the battery in a well-ventilated area.
√
Use proper AC input voltage for charging
as indicated on the charger.
√
Use only a Ballymore authorized battery
and charger.
To Charge Battery
1 Be sure the batteries are connected before
charging the batteries.
2 Open the battery compartment. The
compartment should remain open for the
entire charging cycle.
Maintenance - free batteries
3 Connect the battery charger to a grounded
AC circuit.
4 The charger will indicate when the battery
is fully charged.
Standard Batteries
5 Remove the battery vent caps and check
the battery acid level. If necessary, add
only enough distilled water to cover the
plates. Do not overfill prior to the charge
cycle.
6 Replace the battery vent caps.
7 Connect the battery charger to a grounded
AC circuit.
8 The charger will indicate when the battery
is fully charged.
9 Check the battery acid level when the
charging cycle is complete. Replenish with
distilled water to the bottom of the fill tube.
Do not overfill.
Dry Battery Filling and
Charging Instructions
1 Remove the battery vent caps and
permanently remove the plastic seal from
the battery vent openings.
2 Fill each cell with battery acid (electrolyte)
until the level is sufficient to cover the
plates.
Do not fill to maximum level until the battery
charge cycle is complete. Overfilling can
cause the battery acid to overflow during
charging. Neutralize battery acid spills with
baking soda and water.
3 Install the battery vent caps.
4 Charge the battery.
5 Check the battery acid level when the
charging cycle is complete. Replenish with
distilled water to the bottom of the fill tube.
Do not overfill.
Summary of Contents for SM0114113
Page 3: ......
Page 5: ......
Page 17: ...OPERATOR S MANUAL with Maintenance Information Decals 12...