OPERATOR
’S MANUAL
with Maintenance Information
Maintenance
52
4 Press and hold the function enable switch
on the joystick.
5 Raise the platform approximately 6.6 ft /
2 m from the ground.
6 Press the drive function select button.
7 Choose a point on the machine; i.e.,
contact patch of a tire, as a visual
reference for use when crossing the start
and finish lines.
8 Bring the machine to top drive speed
before reaching the start line. Begin timing
when your reference point on the machine
crosses the start line.
9 Continue at full speed and note the time
when your reference point on the machine
passes over the finish line. Refer to
specifications.
B-10
Test the Slow Drive Speed
BALLYMORE/ DINGLI requires that this
procedure be performed every 250 hours or
quarterly, whichever comes first.
Proper drive functions are essential to safe
machine operation. The drive function should
respond quickly and smoothly to operator
control. Drive performance should also be free
of hesitation, jerking and unusual noise over
the entire proportionally controlled speed
range.
Perform this procedure with the machine on a
firm, level surface that is free of obstructions.
1 Create start and finish lines by marking
two lines on the ground 40 ft / 12.2 m
apart.
2 Turn the key switch to platform control and
turn the red Emergency Stop button
clockwise to the on position at both the
ground and platform controls.
3 Lower the platform to the stowed position.
4 Press the slow speed select button.
a
a slow speed select button
Summary of Contents for SM0114113
Page 3: ......
Page 5: ......
Page 17: ...OPERATOR S MANUAL with Maintenance Information Decals 12...