SPECIAL PRECAUTIONS WHEN USING GAS.
•
Check that the feed line and the train comply with current law and
regulations.
•
Check that all the gas connections are properly sealed.
•
Do not leave the equipment on when it is not in use and always close
the gas cock.
•
If the user is absent for a prolonged period of time, close the main
gas feed tap to the burner.
•
If you smell gas:
- do not operate electrical switches, phones or any other object
that may cause sparks;
- open immediately doors and windows to create a draught to
clear the air in the room;
-
close the gas cocks;
- have professionally qualified personnel correct the fault.
•
Do not obstruct ventilation openings in the room where there is gas
equipment. Otherwise, dangerous situations may arise with the build
up of toxic and explosive mixtures.
RESIDUAL RISKS
•
Even though the product was designed in compliance with the obli-
gatory standards, residual risks may still be present during correct
operation. They are signalled on the burner through special Picto-
grams.
CAUTION
Moving mechanical organs.
CAUTION
Materials at high temperature.
CAUTION
Powered electric panel.
ELECTRIC SAFETY WARNINGS
•
Check that the equipment has a suitable ground system, carried out
following safety standards in force.
•
Have qualified personnel check that the electric system is adequate
to equipment maximum power consumption indicated on the plate.
•
For the mains supply connection is required an omnipolar switch
with a contact opening gap equal or above 3 mm in accordance with
current safety regulations (condition of overvoltage category III).
•
Remove the external insulating seal of the supply pipe necessary for
the connection, preventing the cable to touch metal parts.
•
The use of any electrically fed components entails complying with
certain fundamental rules, including the following:
- do not touch the equipment with parts of the body that are wet or
damp or with damp feet;
- do not pull on electrical cables;
- do not leave the equipment exposed to atmospheric agents
(such as rain or sun etc.) unless there is explicit provision for
this;
- do not allow the equipment to be used by children or inexpert
persons;
- The power supply cable for the equipment must not be replaced
by the user. In case of cable damage, turn the equipment off. To
replace it contact qualified personnel only;
- If you decide not to use the equipment for a certain period of time
it is advisable to switch off the electrical power supply to all com-
ponents in the system that use electricity (pumps, burner, etc.).
•
Use regulation-compliant flexible cables EN60335-1:EN 60204-1
- in case of PVC sheath, at least type H05VV-F;
- in case of rubber sheath, at least type H05RR-F; LiYCY
450/750V
- without any sheath, at least type FG7 o FROR, FG70H2R
•
The electric equipment works correctly when the relative humidity
does not exceed the 50% at a maximum temperature of +40° C.
Higher relative humidity are allowed at lower temperatures(e.g. 90
% at 20° C)
•
The electric equipment works correctly at altitudes of up to 1000 m
above the see level.
IMPORTANT
We hereby declare that our gas, liquid and mixed forced drau-
ght burners respect the minimum requirements of the European
Directives and Regulations and are compliant with European
standards.
A copy of the EC declaration of conformity is supplied with the
burner.
ENGLISH
4 / 42
0006160079_202008
Summary of Contents for TBML 90P
