3
Juice collect cup
To collect the juice
1. Assemble the juice container on the main body.
4
Pulp collect cup
To collect the pulp
5
Feeding Mouth
The main components of the juice is used for putting food.
6
Screw
The main components to squeeze the food
7
Filter components
The main components of the juice, the juice, slag separation,
and the cleaning vessel and the filtering net bracket on the
juice and slag.(with small holes)
8
Juice container
The main components to juice
2.
Install the filter components, which has only one direction.
9
Juice outlet component To make the juice flow out
10
Main body
The main components to offer the energy.
Chapter Three – How to Use
Before using the product, please thoroughly wash the parts that will contact the ingredients (see Chapter
Four – Maintenance)
Note: The product is provided with a protective switch. It will not work if the lid is not covered.
How to Use
Please install and use the product according to the following procedures
：
3. Place the screw in the center of the filter, then insert it while rotating.
SILICONE PAD - DRIP STOP ELEMENT
·
If filter and screw are not installed correctly, the lid will not be covered.
Underneath the cup, there is a silicone pad which allows all the juice to only discharge from the fresh
juice outlet mouth.
Be sure that this silicone pad is always at its place before starting to make juice.
The silicone pad is removable, simply grab onto one side of the silicone pad and pull out. You can easily
loose this little silicone pad when cleaning. Therefore take caution when cleaning. Place back the silicone
pad immediately after cleaning the juice cup, so that it will not get lost.
4. Align the triangle on the lid with the unlock mark on the juice container, then rotate it in the clockwise
direction until the triangle aims at the lock mark.
Silicone
pad
Open
Close
