CONTACTS
25
CLUTCH POWER SUPPLY (POSITIVE POLE)
26
CLUTCH POWER SUPPLY (NEGATIVE POLE)
27
CLUTCH HALL SENSOR
14 – 15
START/STOP CONTACT
14 – 16
OPEN CONTACT
17 – 18
PHOTOCELL CONTACT (Normally Closed )
17 – 19
PRESSURE SAFETY DEVICE CONTACT (Normally closed)
20 – 21
OPENING LIMITSWITCH (Insert a bridge if not used)
20 – 22
CLOSING LIMITSWITCH (Insert a bridge if not used)
23 – 24
STOP (Normally Close)
1 – 2
COURTESY LIGHT CONTACT, without electric tension ( Max. 10 A / 230 V )
3 – 4
ANTENNA ( Metallic mesh on contact 4 )
5 – 6
PHOTOCELLS POWER SUPPLY 24 VAC ( Max 150 mA )
7 – 8
BLINKER CONTACT ( Type Quick MAX. 10 A 230 Vac )
9 – 10
MAIN POWER SUPPLY 230 VAC / 50 Hz ( Phase on 10 )
T
GROUND
11 – 12
MOTOR OUTLET ( Max 500 W 230 Vac )
13
COMMON OF THE MOTOR
BOARD DEFAULT PARAMETERS
T3 EXTRA TIME = 4,5 SECONDS
T4 TIMING OF PHOTOCELLS OPERATED CLOSURE = 3 SECONDS
T5 TIMING OF AUTOMATIC CLOSURE = 30 SECONDS
T6 COURTESY LIGHT TIMING = GATE OPEN PILOT LIGHT
T7 PEDESTRIAN OPENING = 6 SECONDS
T8 MOTOR BRAKE = 270 ms
F2 PRE-BLINKING OPENING = ON
F3 PHOTOCELL ENABLED DURING OPENING PHASE = OFF
F4 TRANSFORM PRESSURE SAFETY DEVICE CONTACT IN PHOTOCELL 2 CONTACT = OFF
F5 TRANSFORM “OPEN” CONTACT IN “PEDESTRIAN OPEN” CONTACT = OFF
- 5 -
