config switch ‘eth0′
option enable ’1′
option enable_vlan ’1′
option reset ’1′
config interface ‘lan’
option proto ‘static’
option ipaddr ’10.0.1.1′
option netmask ’255.255.255.0′
option defaultroute ’0′
option peerdns ’0′
option nat ’1′
option ifname ‘eth0.1′
option type ‘bridge’
config switch_vlan
option device ‘eth0′
option ports ’0 1 2 4 8t’
option vlan ’1′
config interface ‘wan’
option ifname ‘eth0.2′
option proto ‘dhcp’
config switch_vlan
option device ‘eth0′
option vlan ’2′
option ports ’3 8t’
start router web server:
$ /etc/init.d/uhttpd start
$ /etc/init.d/uhttpd enable
That’s all. Good luck!
forum discuss link:
http://www.bananapi.com/index.php/forum/general/417-banana-pi-bpi-r1-openwrt-image-2-0-release-note#1229
Wiki link:
http://wiki.geiges.net/doku.php?id=openwrt_bpi-r1
Lamobo Openwrt image
68
Summary of Contents for BPI-R1
