BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Document # P46250 Rev. -
© Copyright
BAND-IT-IDEX, Inc. 2008
All rights reserved
www.BAND-IT-IDEX.com
Page 2 of 3
GRC003 Heavy Duty
Hand Tool
NOTE
: Periodically apply food-grade white lubricant or equivalent to tension screw thread (Item 6
on page 3) to prevent excessive wear.
If tool fails to securely grip tail of clamp, follow gripper cleaning instructions above.
Refer to website for warranty information:
http://www.band-it-idex.com/warranty.html
3. Replace pin. Gripper spring must be
seated in tension screw hole. Align
gripper hole with slide block hole, insert
pin in hole and hammer pin in place.
2. Using a wire brush, clean all
foreign matter from teeth.
1. Remove gripper. Align gripper pin
hole with notch in tool frame. Using a
punch and hammer, punch pin out of
slide block.
Gripper Cleaning Instructions:
Cleaning and
Warranty