Band-it GRG402 Giant II Operating Instructions Download

Page: 2 / 3

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925

Document # P46450 Rev. -

BAND-IT-IDEX, Inc. 2008

www.BAND-IT-IDEX.com

Page 2 of 3

GRG402 Giant II

Hand Tool

NOTE

: Periodically apply food-grade white lubricant or equivalent to tension screw thread (on

page 3) to prevent excessive wear.

If tool fails to securely grip tail of clamp, follow gripper cleaning instructions above.

3. Replace pin: Align gripper hole with
slide block hole, insert pin in hole and
hammer pin in place.

2. Using a wire brush, clean all
foreign matter from teeth.

1. Remove gripper. Align gripper pin
hole with notch in tool frame. Using a
punch and hammer, punch pin out of
slide block.

Gripper Cleaning Instructions:

Cleaning and
Warranty

Summary of Contents for GRG402 Giant II

Page 1: ...r as possible to avoid buckle sliding into tool nose Apply tension by turning handle of tool 4 Place finger on BAND IT Band at buckle bridge while tensioning with tool handle When you feel BAND IT Ban...

Page 2: ...read on page 3 to prevent excessive wear If tool fails to securely grip tail of clamp follow gripper cleaning instructions above Refer to website for warranty information http www band it idex com war...

Page 3: ...e and female of foreign matter then apply two drops of high strength locking compound Loctite 271 or equiv onto male threads and connect parts together Apply 3 oz of white lubricant or equiv to tensio...