IT5000-C / IT6000-C
3/8” IT Tool
www.BAND-IT-IDEX.com
Document # P48850 Rev. C
© Copyright
BAND-IT-IDEX, Inc. 2015
All rights reserved
Page 17 of 36
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Operating
Manual
Clamp Placement
Buckle location is critical to clamp performance. Use the following guidelines as a reference.
•
Band target area must be wider that the band and tool head with some additional
clearance for variation side to side.
•
Do not install clamps at an angle
•
Buckle locations cannot be over air gaps
•
Avoid installing buckles on flat surfaces when possible
•
On large oval shapes locate buckle on smaller
radius.
•
Do not install clamps around square corners
•
Do not install clamps on tapered surfaces or on tube bends
•
Tie-Lok & JR Clamp advised min installed diameter is 1”
For specific questions contact BAND-IT-IDEX Customer Service at 1-800-525-0758 or
303-320-4555 for more information.