IT5000-C / IT6000-C
3/8” IT Tool
www.BAND-IT-IDEX.com
Document # P48850 Rev. C
© Copyright
BAND-IT-IDEX, Inc. 2015
All rights reserved
Page 28 of 36
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Operating
Manual
Production tools will experience wear of specific parts. High cycle tools may experience a
component failure that is not considered a wear part. Preventative maintenance, including
regular cleaning and lubrication will reduce the replacement frequency of these parts. Threaded
fasteners may be replaced by off the shelf parts, but they must be an identical replacement or
tool function may be affected.
Please have both the tool model and serial numbers available when calling the factory for
service or assistance. Contact BAND-IT-IDEX Customer Service at 1-800-525-0758 or
303-320-4555 for more information. Part numbers are subject to change.
Part #
Description
I51065
Maintenance Cover Assembly: includes assembled maintenance cover,
two clevis pins, two retaining rings (pg. 27)
I51066
Tension Block Assembly: includes tension block, tension gripper,
tension pin, and 2 springs (pg. 28)
I51069
IT6000-C Cutter Blade with four screws (pg. 29)
I51067
IT6000-C Knife Assembly Kit: includes assembled knife, dimple punch,
and spring pin (pg. 31)
I51004
IT5000-C Knife (pg. 31)
I51057
IT5000-C Cutter Blade (pg. 29)
I40087
Hanger bracket; for attaching tool balancer (seen on pg. 7)
I51064
Front gripper ball (pg.29)
M24187
Front cutoff lever (pg.31, step 5, attached to knife)
I14387
Head pin (pg.31, pin retaining M24187 to head)
Socket head cap screws M5 x 10mm; for balancer bracket & cover plate
Lubricant, Chevron Rykotac Grease EP (or equivalent)
Several fasteners require Loctite, Blue - Medium strength.
Maintenance: Replacement Parts