IT5000-C / IT6000-C
3/8” IT Tool
www.BAND-IT-IDEX.com
Document # P48850 Rev. C
© Copyright
BAND-IT-IDEX, Inc. 2015
All rights reserved
Page 33 of 36
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Operating
Manual
1)
Remove the one cutoff link and two pins shown
2)
Remove the tool head by removing one flat head screw (3mm hex) on opposite side
3)
Remove tool head assembly by sliding it along keyway in tool body
4)
Lift cutter arm and knife assembly out of tool head
5)
Push the pin out of knife assembly to remove the cutter arm
6)
Inspect cutting edge for chips and excessive wear. Make sure knife is well lubricated.
7)
For IT6000-C only: the Dimple Pin height should be 0.120” minimum. Inspect dimple pin
for excessive wear.
Note: Be careful not to let ball bearing fall out of gripper guide. Further cleaning of the gripper
guide and ball bearing can occur here if necessary.
Maintenance: Knife Inspection & Replacement
Step 1
Step 4
Step 5
Cutting Edge
Dimple Pin Height
0.120” Minimum
Lightly lubricate all
sides of cutting knife
.
Step 3
Front
Cutoff
Lever
Head Pin