BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Document # P07888 rev. F
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
www.BAND-IT-IDEX.com
Page 1 of 2
Ultra-Lok
Free End
Clamping
Instructions
Warning:
Always wear safety glasses when operating tool.
UL2000, UL4000, UL9000, UL9010 Ultra-Lok Tools:
1.
Break off an Ultra-Lok Free-End tie
from the roll. Slide the buckle onto
band with indented arrows pointing
in same direction and same side up.
Slide buckle all the way onto band
until it comes to a stop between the
two buckle dimples at opposite end
of tie.
2.
wrap tie around object to be
clamped. Insert the tie through
buckle once for single-wrap or
twice for double-wrap.
3.
If desired, you may
pre-form a clamp in
the same fashion
as step 2.
4.
Position the tie on
the object you are
clamping. Pull the
wrapped tie hand-
tight.
Prepare Band-It Ultra-Lok tool for
operation as described in owners
manual. With cut-off handle down
as shown, insert clamp tail into tool
head slot.
5.
Operate tool until proper tension
has been applied. Lift the cut-off
handle to cut tail off and form a
lock. Excess band can be
removed by pulling out from rear
of tool or reversing the drill.
6.
Completed clamp should appear as shown.
Side view of completed clamp
Tap down buckle
for proper function
WWW.CABLEJOINTS.CO.UK
THORNE & DERRICK UK
TEL 0044 191 490 1547 FAX 0044 477 5371
TEL 0044 117 977 4647 FAX 0044 977 5582
WWW.THORNEANDDERRICK.CO.UK
