– Must be performed by a technician –
– Must be performed by a technician –
159
Service
8B. Service
Test Mode
Troubleshooting
8B-6-3 Various Projector Settings
– Must be performed by a technician –
(1) Preparing the Remote Controller
z
z
Be sure to observe the following regarding the dry cell batteries of the remote controller. Failure to
do so may cause the batteries to leak fluid or burst, possibly resulting in burns or injury.
•
Do not use other than the specified batteries.
•
Do not mix up the polarity indications (+ and -).
•
Do not charge, heat, disassemble, short circuit or place the batteries in a fire.
•
Do not leave dry cell batteries that have run out or are past the recommended use date indicated
on the batteries in the remote controller.
•
Do not mix different types of dry cell batteries or use new and old batteries together.
•
Should battery fluid adhere to equipment, do not touch the battery fluid directly. If you happen
to touch the battery fluid, rinse thoroughly with water and consult a doctor.
Insert the dry cell batteries into the remote controller
Remove the battery cover.
Insert the dry cell batteries.
Confirm the polarity indications (+ and -) on the dry cell batteries and insert the batteries
correctly.
Close the battery cover.
