Installation and Operations Manual
— VP Gate Operator
3
B&B ARMR
A Division of B&B Roadway and Security Solutions VP Revision B1
Important Safety Information
TO REDUCE THE RISK OF SERIOUS INJURY OR DEATH, READ AND
FOLLOW ALL INSTRUCTIONS PROVIDED IN THIS MANUAL
.
1.
Hydraulic slide gate operators are intended for vehicular use only. Pedestrians
should use a separate walkthrough entrance designed for on-foot traffic.
2.
Keep children away from gate movement area and off the gate operator. Never
let children operate or play with gate controls.
3.
Install all warning signs provided with the gate operator so that they are
clearly visible from both sides of the gate.
4.
It is the responsibility of the specifier, designer, purchaser, installer and end-
user to ensure the gate system is properly configured for its intended
application.
5.
Use the emergency manual release only when the gate is not in motion.
6.
Test gate operator and all related safety devices monthly. The gate must
reverse or stop when a safety device is tripped. The gate must stop upon
sensing a second sequential safety violation before reaching a limit switch. If
the gate utilizes a transmitting device on a safety edge, check the battery on a
regular basis to ensure proper operation. Failure to adjust and re-test the gate
operator properly can increase the risk of injury.
7.
This gate operator utilizes a pumping system which contains hydraulic fluid.
Consult local EPA (Environmental Protection Agency) regulations for
damming requirements (if any) around the base of the gate operator.
8.
Service and maintenance of the gate operator should be performed on a routine
basis by a qualified technician. Attempts to service the gate equipment by non-
qualified personnel could result in serious injury and will void all applicable
warranties.
SAVE THESE INSTRUCTIONS.
THIS MANUAL SHOULD BE LEFT WITH A RESPONSIBLE INDIVIDUAL AT THE
INSTALLATION SITE AND KEPT IN A DESIGNATED LOCATION FOR
MAINTENANCE OR TROUBLESHOOTING OPERATIONS
