Driver Software Installation
Manual Documentation Number 3PCIoUx-1008
Chapter 3
39
8.
In the
Advanced Settings
dialog set the
Receive buffer: Low,
Transmit buffer: Low, RTS Control
and
Hardware handshaking
Hysteresis level (characters)
as necessary.
Note: For more information on advanced settings refer to Chapter 4
Figure 29. The Advanced Port Setting Dialog
9.
Click
OK
to return to the
Communications Port Settings
.
10.
Click
Cancel
to return to the
Assign Ports
dialog.
11.
Repeat the procedure for any additional ports on the list.
12.
Re-start your computer so the changes will take effect.
Note: After restarting the computer, you can check the Ports applet to
make sure that the driver assigned the COMx names to the serial
ports; however, you must not change the settings of the serial port
within the Ports applet.
