Chapter 4
Operation
The following items should be checked before attempting to operate the ironer:
1. Read and follow caution, warning and direction labels attached to the ironer.
2. Check incoming supply voltage to be sure that it is the same as indicated on the serial decal.
3. GAS MODELS – check to assure that the ironer is connected to the type of gas indicated on
the serial decal.
4. GAS MODELS – be sure that ALL gas shut-off valves are in the open position.
5. Be sure ALL back panels (guards) and electric box covers have been replaced.
6. Check ALL service doors to assure that they are closed and secured in place.
ALL ironers are thoroughly tested and inspected before leaving the factory. However, a pre-
operational test should be performed before the ironer is placed into service. It is possible that
adjustments have changed in transit or due to marginal location (installation) conditions.
4.1
Heat Circuit Operation Test
1. Gas Models
(a) When the ironer is first started (during initial start-up), the burner has a tendency not
to ignite on the first attempt. This is because the gas supply piping is filled with air, so
it may take a few minutes for this air to be purged from the lines.
(b) If a gas system fault occurs, the gas supply to the machine is shut off and AL6 (gas
alarm) appears on the display.
(c) After the beep ends, reset the gas system by pressing the + and - buttons simultane-
ously (see alarm chapter). If the fault persists, this could be due to one of the following
problems:
17
