Diamond PD Power Drive : Instruction
Manual
9
Controll-A-Door
®
Diamond PD & Roll-A-Pro
TM
Home Owner’s Manual
© Copyright 2014 B&D Doors
7. Safety Testing
Fig. 7.2
Fig. 7.1
6. Opener Safety & Security
WARNING!
If the door is closing
and is unable to re-open when
obstructed, discontinue use.
Do not use a door with faulty
obstruction sensing. Contact
your dealer for support.
7.1 Test the Close Cycle
a. Press the transmitter to open the door.
(Fig 7.1)
b. Place a piece of timber approximately 40mm high
on the floor directly under the door
(Fig 7.2)
.
c. Press the programmed transmitter to close door.
d. The door should strike the object and re-open.
7.2 Testing the Open Cycle
a. Press the transmitter to close the door
(Fig. 7.1)
.
b. Press again to open the door.
c. When the door reaches approximately half way,
firmly grab the door’s bottom rail - the door should
stop.
If the door does not reverse readily when closing, or
stop when opening, put the door into manual and
contact your installer immediately for a door service.
7.3 Test the Manual Door Operation
Periodically disengage the opener (Section 6.1) and
manually operate the door. The door must be smooth
to operate by hand. The force required on the bottom
rail should not exceed 15 kg.
7.4 Setting the PET Mode position
When activated, PET mode drives the door to the preset
position from the close position.
a. Drive and stop the door at the desired PET mode
open position by pressing the transmitter button
coded for Open/Stop/Close operation.
b. Press and hold the OPEN button on the opener for
six (6) seconds until the OPEN and CLOSE LED’s are
lit to record the new PET position.
To program a transmitter button to operate PET mode
refer to 8.5 Setting PET Mode.
Periodically test if a PET mode button is pressed, while
the door is moving, the door will stop or when the door
is in the PET position, the door will close.
40mm
Select the button on
the transmitter that has
been programmed to
operate the door.
If transmitter is not programmed,
Refer to Section 8 to program
transmitter.
CAUTION:
Take care when
completing a safety test. Failure
to follow this warning can result
in serious personal injury and/or
property damage.
