B&D Controll-A-Door P Diamond SDO-2v2, Instruction Manual

Press CODE SET 
button three times 

Select one of the 
four buttons (not 
programmed yet ) you 
wish to use to control 
the Auxiliary out put

Press CODE SET 
button four times

Select one of the 
four buttons (not 
programmed yet ) you 
wish to use to control 
the Vacation Mode

Fig. 31

Fig. 30

Coding Transmitters

Step 17.3 - Setting the Transmitter to Operate 

Vacation Mode

The opener can be programmed into a “Vacation Mode” 
where the opener will not respond to any transmitter except 
one preprogrammed unit.

a.  Press CODE SET button three times.  The CODE SET 

LED will illuminate and the courtesy light will 

fl

 ash 

slowly (once every two seconds) to indicate Vacation 
learning mode is active. 

(Fig. 30)

b.  Choose a transmitter button not already coded into the 

receiver.  Press this button and the CODE SET LED will 
begin to 

fl

 ash.  

c.  Press the same transmitter button again.  The CODE 

SET LED will illuminate for one second and then go out, 
and the courtesy light will also switch off.  This indicates 
the code has been stored 

(Fig. 30)

.

d.  To activate Vacation Mode, close the garage door and 

press the coded button transmitter for 5 seconds. 
The CODE SET LED will illuminate to indicate that the 
opener is in Vacation Mode.

e.  To exit Vacation Mode press the transmitter button 

momentarily until the CODE SET LED turns off.

Step 17.4 - Setting the Transmitter to Operate the 

Auxiliary Output

It is possible to operate other devices (e.g. alarm systems) 
using one of the spare buttons of a multi-channel transmitter 
coded into the Auxiliary Output feature.

a.  Press CODE SET button four times. The CODE SET 

LED will illuminate and the courtesy light will 

fl

 ash 

quickly (twice per second) to indicate that learning 
mode for the Auxiliary Output is active.

b.  Choose a transmitter button not already coded into the 

receiver.  Press this button and the CODE SET LED will 
begin to 

fl

 ash. 

c.  Press the same transmitter button again.  The CODE 

SET LED will illuminate for one second and then go out, 
and the courtesy light will also switch off.  This indicates 
the code has been stored 

(Fig. 31)

.

Diamond PD Power Drive : Instruction Manual

© Copyright 2012 B&D Doors

19

Controll-A-Door

®

 P

Diamond SDO-2v2

Instruction Manual